| Standard Industrial PLX Laser tubes | |
|---|---|
|
Output power warranty : Two years, unlimited hours, on all PW series systems One year, unlimited hours, on all standard PLX series tubes, unless otherwise noted. All PLX series co2 lasers are Made in U.S.A. Specifications subject to change without notice |
|
PLX110, PLX100, PLX90, PLX80, PLX70,
PLX60, PLX50 Photo
Operating Output Power = ' indicated on model number ' TEM00 beam dia @ 1/e2 FW = 7 mm Beam divergence, full angle = 2.2 mrad (M2 ~ 1.1 ) Physical Tube Length = Model dependent Tube outside diameter (OD) = 85 mm Also available OD = 70 and 80 mm
|
|
PLX45, PLX35, PLX20 Photo
Operating Output Power = ' indicated on model number ' TEM00 beam dia @ 1/e2 FW = 6 mm Beam divergence, full angle = 2.4 mrad (M2 ~ 1.1 ) Physical Tube length = Model dependent Tube outside diameter (OD) = 80 mm Also available in OD = 60, 70 and 85 mm
|
|
More specs for all PLX Series:
Operating mode: CW or Pulsed Power stability (after 6 minutes warm up); Laser power stability is also a function of the power supply's "current stability". Our power supplies are better than 1% but you should not expect 1% laser power stability if your own power supply is unregulated or is +/-10% .
Wavelength: 10.6 micron nominal
All tubes require water cooling.
Minimum flow rate:
1/4 GPM (1 liter per minute)
1/3 GPM (1.5 liter per minute) for PLX60 and above
Nominal coolant temperature : 60 to 90 F (15 to 33 C )
Recommended coolant: 80% distilled water + 20% Dow Frost
(Propylene Glycol, yellow or colorless).
We do NOT recommend Ethylene Glycol in any concentration.
|
|
Laser systems, specs & prices | Re-gas and other service prices | Fact or fiction, check it out! | Power supplies | International prices | Pictures of lasers | Misc. surplus equipment | Frequently asked questions Parallax Technology, Inc. Web page created and maintained by Parallax Marketing Department. |